Bike antenna

Spacer that keeps the rope away from the wheel - Made of: Plastic, rubber, aluminum, steel och cord.

- Length approx. 60 cm
- Can be mounted on most frames. Be careful because of the clamp on the Carbon frame
- Detachable antenna, the bracket and the antenna part are separable by unscrewing the antenna (nut and bolt)
- Cleaned with mild detergent and soft cloth

Note! The spacer must be attached to the steering column with clamps and/or rubber covered threaded rod. Attach the pull cord around the steering column and then thread it through the loop at the front of the spacer.

Warning! Attaching the pull line only to the loop at the far end of the spacer is not recommended! See image for how the spacer should be used.

Safety Warning:
Always check the integrity of the product before each use. Use of a damaged or worn product may cause accidents and is therefore not recommended.

Improper use of the leash attached to the looped end of the spacer may damage the product.

Correct use of the product:
1. The distance adapter must be mounted on the steering column. Before assembly, check if the steering would be obstructed (the brake for the movement of the shift bow must be unobstructed, etc.). If there is an obstacle, check if the adapter can be mounted differently.
2. Aim to insert the inner part of the jumper between the frame tubes so that the U-shaped part faces forward. Place the part with the nut on the outside of the steering column. Then tighten the inner and outer parts so that they are secure but the frame remains undamaged.
3. Attach the threaded end of the stick to the adapter.
4. Attach the flexible leash to the bicycle frame, then pass it through the looped end of the stick. Finally, attach the leash to the dog's harness.
5. When you are finished using the spacer, unscrew it from the adapter and hold it by the rubber mount. It is not necessary to disassemble the adapter.